Installation
Description
Start and
Programmes Laundry
Warnings and
Suggestions
Maintenance and
Care Troubleshooting Service
GB
3
The Clean Filter icon reminds you to
clean the filter every time you use the dryer (see
Maintenance).
The On/Off indicator light signals that your dryer
is in use or ready to select a programme.
The ON/OFF button : If the dryer is running and
this button is pressed, the dryer stops. Press again,
the dryer restarts. If you have not opened the door,
press START button to continue.
The Progress icons :
show you the status of the programme. They show
each stage of the programme by the corresponding
icon turning on (see Start and Programmes).
The PROGRAMME Selection buttons sets the
programme: press the button corresponding with the
programme you want to select (see Start and
Programmes).
The START/CANCEL button starts a selected
programme. When you press this button there will be
one short beep and the progress icons will flash
on/off to confirm the action. If you have not set a
programme, the buzzer will beep four times. When a
programme is running, holding this button in gives one
long beep and cancels the programme and stops the
dryer (see Start and Programmes).
The OPTION buttons/icons: these buttons select
available options for your selected programme (see
The Controls). The icons indicate that the option has
been selected.
The Empty Water icon signals that the
water container should be emptied. When it is flashing
it indicates that the container is full.
The light will take a few seconds to go out after
replacing the empty container, the dryer must be
running for this to happen (see The Controls).
Control panel
Dryer Description
PROGRAMME Selection
Buttons
START/CANCEL
Button
OPTION
Buttons
Time and Icon
Display unit
On/Off
Light
ON/OFF
Button
To open the door The features
Press and release the front
panel in position shown
Water container
Air intake
grille
Rating plate
Door catch
Filter
Door latch
Model &
Serial
numbers
Condenser cover handle
(Pull to open)
Condenser cover