Filter
Top Products
10
5) PROGRAMME START LIGHT
This lights up when the START button has been pressed.
6) WASH TIME
When a programme is selected the relevant indicator will light up to show the minimum
possible wash time.
Selecting a greater time using the special button will cause the corresponding indicator to light up.
Note: The wash time can vary automatically, depending on the temperature selected.
“SPIN SPEED” button
The spin cycle is very important to remove as much water as possible from the laundry without
damaging the fabrics. You can adjust the spin speed of the machine to suit your needs.
By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle
can be cancelled.
To reactivate the spin cycle press the button until you reach the spin speed you would like to set.
To prevent damage to the fabrics, it is not possible to increase the speed over that which is
automatically suitable during the selection of the program.
It is possible to modify the spin speed without to pausing the machine.
Note:
The machine is fitted with a special electronic device, which
prevents the spin cycle should the load be unbalanced.
This reduces the noise and vibration in the machine and so
prolongs the life of your machine.
I
11
“DIGITAL” Display
The display’s indicator system allows you to be constantly informed about the status of the
machine:
1) WASH TEMPERATURE
When a programme is selected the relevant indicator will light up to show the maximum
possible wash temperature.
Selecting a lower temperature using the special button will cause the corresponding indicator
to light up.
Note: The temperature must be adjusted before selecting WASH TIME.
2) SPIN SPEED
Once the programme has been selected, the maximum spin speed allowed for that
programme appears on the display. Pressing the spin button will reduce the speed by 100
rpm each time the button is pressed. The minimum speed allowed is 400 rpm, or it is
possible to omit the spin by pressing the spin button repeatedly.
3) DELAY START LIGHT
This flashes when delay start has been set.
4) CYCLE DURATION
When a programme is selected the display automatically shows the cycle duration, which
can vary, depending on the options selected.
Once the programme has started you will be kept informed constantly of the time remaining
to the end of the wash.
L
2
3 5
{
{
{
1
4
6
{
PROGRAMME selector with "OFF" position
When the programme selector
is turned the display lights up to
show the settings for the
programme selected.
N.B. To switch the machine off,
turn the programme selector to
the “OFF” position.
Press the "Start/Pause" button to start the selected cycle.
Once a programme is selected the programme selector remains stationary on the selected
programme till cycle ends.
Switch off the washing machine by turning the selector to "OFF".
Note:
The programme selector must be returned to the "OFF" position
at the end of each cycle or when starting a subsequent wash
cycle prior to the next programme being selected and started.
N
Buttons indicator light
These light up when the relevant buttons are pressed.
If an option is selected that is not compatible with the selected programme then the light on
the button first flashes and then goes off.
O
“WASH TIME” button
By selecting this button (active only on COTTON and MIXED FIBRES programmes) there is
a choice of 3 levels of wash intensity, depending on how much the fabrics are soiled.
Once the programme and wash temperature have been selected the wash time indicator is
automatically set to the minimum allowed; pressing the button increases the level and the
settings for the cycle duration are also adjusted accordingly.
M