Hoover Washer Dryer Washer/Dryer User Manual


 
8
E
START DELAY BUTTON
Appliance start time can be set with this button, delaying the star by 3, 6 or 9 hours.
Proceed as follow to set a delayed start:
Select a programme (“STOP” indicator light blinks)
Press Start Delay button (each time the button is pressed the start will be delayed by 3, 6 or
9 hours respectively and the corresponding light will blink).
Press START to commence the Start Delay operation (the indicator light associated with the
selected Start Delay time stops blinking and remains ON).
At the end of the required time delay the programme will start.
To cancel the Start Delay function:
press the Start Delay button until the indicator lights will be off (The STOP light blinks) and
the programme can be started manually using the START button or switch off the appliance
by turning the programme selector to off position.
D
9
COLD WASH BUTTON
By pressing this button it is possible to transform every programme into a cold washing one,
without modifying other characteristics (water level, times, rythmes, etc...).
Curtains, small carpets, man made delicate fabrics, non coulor fast garments can be safely
washed thanks to this new device.
F
SPIN SPEED CONTROL
ROTATES IN BOTH DIRECTIONS
The spin cycle is very important to remove as much water as
possible from the laundry without damaging the fabrics. You
can adjust the spin speed of the machine to suit your needs.
By adjusting the control, it is possible to reduce the maximum
speed, and if you wish, the spin cycle can be cancelled
altogether-position .
Note:
The machine is fitted with a special electronic device,
which prevents the spin cycle should the load be
unbalanced.
This reduces the noise and vibration in the machine and
so prolongs the life of your machine.
H
PRE-WASH BUTTON
This option is particularly useful for heavily soiled loads and can be used only on some
programmes as shown in the programmes table.
Detergent for this programme should be added to the compartment of the soap drawer
labelled “I” (Please refer to Detergent Drawer Section of manual). We recommend you use
only 20% of the recommended quantities shown on the detergent pack and fabric
conditioner should not be used for this programme.
G
The option buttons should be selected before pressing
the "Start/Pause" button.
CREASE GUARD button
Press the button to select or deselect this function.
The Crease Guard function minimizes creases as much as possible with a uniquely designed
anti-crease system that is tailored to specific fabrics.
MIXED FABRICS - the water is gradually cooled throughout the final two rinses with no
spinning and then a delicate spin assures the maximum relaxation of the fabrics.
DELICATE FABRICS – final two rinses with no spinning and then the fabrics are left in water
until it is time to unload. When you are ready to unload, press the "Crease Guard" button –
this will drain.
WOOLLENS/HAND WASH/SILK – after the final rinse the fabrics are left in water until it is
time to unload and the button indicator blinking.
When you are ready to unload, press the "Crease Guard" button, this will drain and spin
ready for emptying.
If you do not want to spin the clothes and activate drain only:
- Turn the programme selector to the "OFF" position;
- Select programme drain only ;
- Switch on the appliance again by pressing the "Start/Pause" button.