Filter Water container
6
Filter
IMPORTANT: To maintain the efficiency
of the dryer check that the fluff filter is
clean before each drying cycle.
4
4
3
Water Container
The water removed from the laundry during
the drying cycle is collected in a container
at the bottom of the dryer.
When the container is full the ‘EMPTY
WATER’ indicator on the control panel will
light, and the container MUST be emptied.
However, we recommend that the container
is emptied after each drying cycle.
NOTE: Very little water will collect during
the first few cycles of a new machine as an
internal reservoir is filled first.
To remove the container:
1. Gently pull the bottom of the kickplate
so that it unclips from the dryer. The top
section can then be unhinged allowing
the kickplate to be completely removed
(fig. 5).
2. Pull firmly on the handgrip and slide the
water container out of the dryer (fig. 6).
1. Pull the filter upwards (fig. 3).
2. Open filter as shown (fig. 4).
3. Gently remove lint using a soft brush or
your fingertips.
4. Snap the filter together and push back
into place.
Filter Care Indicator
Lights when the filter needs cleaning.
If the laundry is not drying check that the
filter is not clogged.
5
6
40000133.qxd 11-06-03 17:50 Page 6