Filter
Top Products
8
8
Chapter 3: Maintenance and Cleaning
To prevent any risk of burns, all maintenance and cleaning operaons should only be
carried out when the unplugged appliance has cooled down for at least 2 hours.
Before cleaning, set the steam control knob to the “0” or “ ”, unplug the iron from
wall socket, and allow the appliance to completely cool down, and then clean with a
damp cloth, do not immerse the unit into water or other liquids.
Clean and empty the water tank aer every use.
If ironing clothes with high temperature, which is not recommended on the garment
table, this will cause burns to your clothes and residue le on the soleplate of the unit,
it is recommended that you iron over an old cloth to remove any residue from the
soleplate.
Aer use, set the steam control knob to the “0” or “
”, disconnect the unit from
mains socket, empty remaining water from water tank and then store the iron aer it
has been completely cooled down.
Never use scouring pads, abrasive or chemical cleaners, or solvents
Chapter 2.7 - Auto Shut O Funcon
The auto-shut-o funcon automacally switches the iron o if it has not been moved
for a while.
When the LCD panel shows PAUSE status and the buzzer start beeping, the backlight
will turn to RED, the iron has been switched o by the auto-shut-o funcon.
To let the iron heat up again:
Pick up the iron or move it slightly.
The LCD panel shows originally status.
If the temperature of the soleplate has dropped below the set ironing temperature,
the LCD panel will show heang up.
If the iron need heat up aer you have moved the iron, unl it reached required
temperature before you start ironing.
If the iron does not require to heat up aer you move it, but sll indicates seng
mode, the iron can be used.
When Auto-shut-o funcon happens you may hear a sound.
NOTE:
Steam and boiling water will come out of the soleplate, impuries and akes will
be ushed out.
Do not push and hold the self clean buon while ironing.