Filter
Top Products
Page 5For technical questions, please call 1-800-444-3353.SKU 67326
Set Up
For smaller items, place the item
directly over the Wind Tube (17).
Pull the wrist area of gloves up over
the gloves to prevent them from
restricting airow.
For tall items, such as boots, set up
the two Long Tubes (2) as follows:
Slide the Short Tube (1) inside the a.
large end of the Long Tube (2).
Fit the Toe Support (3) onto the b.
remaining end of the Long Tube,
sliding the Tube edge into the slot on
the Toe Support.
To Safely balance the unit, slide the c.
Tube assemblies over diagonally
opposite Wind Tubes (17). The Short
Tube holes are off center, so check
to make sure that the thinner side
of the tube is closest to the center
of the unit so you will have plenty of
room to slide the boot in place.
Slide the boot over the Tube d.
assemblies, making sure that the
entire unit is balanced so it will not
tip over during use.
Operation
Place the dryer on a at, level 1.
surface. Set the control knob to the
off position.
Plug the unit into a 120V outlet.2.
Select Heat or No Heat with the Heat 3.
Switch (14).
Set the Control Knob (13) to the 4.
desired drying time. To set the time
to less than one hour, turn the Knob
past the one hour mark, then return it
to the desired time.
When the items are dry, remove 5.
them, unplug the unit and store in a
dry location away from children.
Note: Drying time will vary depending on
temperature and humidity.
Smaller items will dry faster than
larger items.
Footwear should be dried after every
use to prevent bacteria or fungus
growth.