Filter
Top Products
8.The washing machine must not be used in
the open or in an area of high humidity as
water droplets may form on the electrical
components. Air dry the appliance if the
washing machine components become wet.
9. The washing machine should be placed
in a well-ventilated area, leaving a space
between the appliance and adjacent walls or
furniture.
10. Keep away from heat sources and direct
sunlight to prevent plastic and rubber com-
ponents from ageing.
11. During installation, ensure that the
electric cable is not trapped by the washing
machine and damaged.
1. Make sure that the washing machine is
securely connected to the water supply. Take
the necessary precautions or contact the lo-
cal service centre if the connection is poor or
there is a water leak.
2. Fasten the door handle before opening the
door and then close the porthole. Do not shut
the door violently.
Matters needing attention
Use
Dear customer, For the machine and your
own security, DO NOTREPAIR IT BY YOUR-
SELF! DO NOT USE THE WASHING MA-
CHINE WHICH SOME PARTS ARE LOST!
Trouble shooting
The following circumstances do not constitute problems. Do not contact the maintenance
service until the problem has been confirmed.
problem Possible Cause
Poor connection to power supply
Power failure
Door is not closed properly
Machine has not been switched on
The washing machine fails to
operate
The washing machine does not
fill with water
The water supply and drainage
do not stop
Drainage failure
Strong vibration during spin
drying
Operation stops before com-
pletion of the wash cycle
Excessive foam in the drum
Failure of the drying process
Incomplete drying
Water is not turned on
Water pressure is less than 0.05MPa
The inlet hose has a kink
Water supply failure
The door is not closed properly
Check that the height of the water hose is within 80-100cm
Check that the drain hose is not syphoning
Drainage hose is blocked
Drainage hose end is more than 100cm above the floor
level
Check that all packing bolts have been removed
The washing machine is located on an uneven surface of
is not level
Check that all foam packing has been removed from the
motor
Water of electricity failure
Poor connection to the power source
The detergent is not a low foam type
Excessive detergent has been used
Door is not closed properly
Program has not been correctly set
Check to see if the end of the water drainage hose is
submerged in water
The filter is blocked
The machine is overloaded
The water tap is not tured on
2 15