Haier HWM 80-50 Washer User Manual


 
After using, please clean the lint and foreign materials of the lint filter and lint frame in
time. Otherwise it may influence your using the machine.
Please first pull the power plug from the receptacle before cleaning.
-1
-3
-2
Figure 3
Figure 1
Figure 2
Cleaning the lint filter
The lint filter must be used
during washing.
It must be cleaned in time after
each using.
Take off the lint filter
Put hand at the indicated
position.
Push down to take it off.
(See to Figure 1)
Clean the lint
Put it in water and clean while it
is still wet. (See to Figure 2)
Install the lint filter
After cleaning, insert the
bottom of the lint after filter
(marked with "DOWN SIDE")
into the filter frame, then push
the upper part of the filter in
(marked with "UP SIDE").
(See Figure 3)
1.
2.
3.
9
Using Process
Disposal after washing
After washing, dismount the water
inlet hose.
Do not store water in the tub for long
p e r i o d . D i s c h a r g e t h e
water immediately after each
using.
Pull of the power plug and hang up
the power cord.
Hang up the drain hose.
Wipe off the water drops on the
surface and inside the tub with clean
soft cloth.
Open the cover of the wash for some
time (about one hour), then
close them.
Wipe the complete unit with soft
cloth twisted dry.
Wipe with neutral detergent if too
dirty.
Do not wash it directly by water.
Do no wipe with thinner, petrol,
alcohol, etc.
Thinner
Alcohol
Petrol
Disposal of the complete unit
1.
2.
3.
4.
5.
6.
7.
8.
9.
-1
-2
-3
-4
-5
-6
-7
-8
-9
10.
-10
10
Using Process
Disposal after washing