Haier HWM 120 - BS Washer User Manual


 
13
Spinning
1.
2.
3.
Put the laundries into the spin tub
evenly and smoothly.
Press the gland in the tub properly.
Close the inner and outer cover of the
spin tub.
Spin
Select suitable spin time according to
the laundries, and do spinning.
During spinning, if there's abnormal
sound, it is generally owing to slanting
placement of the laundries. Please stop
the machine and re-order the laundries.
In spinning, it will pause the work if you
open the outer cover of the spin tub.
Close it to resume the spinning.
Selection of the Spin time list 3.
-1
-2
-3
To do spinning and draining or
rinsing with water-filling
together, please first do spinning
for around 1 minute, then do
draining or rinsing with water-
filling. Otherwise the spinning
will stop owing to too much water
stored in the spin tub.
Note:
Laundries
bed sheet or
blanket
Underwear
(knitwear)
Swear
(chemical fiber)
Blending thin
laundries
Spin time
(minutes)
About 4~5
About 2~4
About 1~2
Within 1
minutes
Using Process
Washing sequence
-1
-3
Cleaning the lint filter
The lint filter must be used during
washing.
It must be cleaned in time after each
using.
Take off the lint filter
Put hand at the indicated position.
Push down to take it off.
(See to Figure 1)
Clean the lint
Put it in water and clean while it is still
wet. (See to Figure 2)
Install the lint filter
After cleaning, insert the bottom of
the lint after filter (marked with
"DOWN SIDE") into the filter frame,
then push the upper part of the filter
i n ( m a r k e d w i t h
"UP SIDE").(See Figure 3)
1.
2.
3.
Figure 3
Using Process
Disposal after washing
After using, please clean the lint and foreign materials of the lint filter and lint frame in
time. Otherwise it may influence your using the machine.
Please first pull the power plug from the receptacle before cleaning.
-2
14
Figure 2
Figure 1