Filter
Top Products
Attention:
After switiching on the power,the function of the "Air dry" and "reserve"is not selected at
the same time.
Only after the program with the spin is set,"Air dry"program can be selected;selecting the
other program without spinning,"Air dry"program can not be selected that is the button of
"Air dry"is no reaction.
A
IR
DRY
RESER
VE
WATER
LEVEL
After you open the package, please lean the washing
machine gently downon soft items ( like the towel cloth,
blanket, etc. ). Install the bottom plate to the bottom of
the machine with the eight screws by a cross
screwdriver, then lift the machine up gently. See to the
figure:
Back
Front
Soft items
Screw
Bottom plate
The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground
will result in unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
Fasten
Loosen
High
Low
the adjustable nut
the adjustable leg
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly,loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Install the bottom plate
Adjust the Installation position
Installation and adjustment
4 Push the " water level" button, select suitable water level
After switching on the power, the washing machine will execute fuzzy program automatically to detect the cloth.
After defection, it can set the water level automatically. To select other water level, first push the "start/pause"
button, then push the "water level" button to set the water level.
5 Push the "reserve" button to select suitable reserve
wash program
After switching on the power, the reserve program is set to off mode automatically. If you need to
set the washing procedure to be finished at reserved time, please push the " reserve "button to
set the reserve wash program. Refer to reserve button in Page 10 for selection.
Confirm the operation of reserve program
When the "reserve" function is activated, the indicator light of the program you have set
will be off. The "reserve (hour)" and "time remain" indicator lights will be on. During
reserve procedure, push the "reserve" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
need to switch off the power and make new selection.
7 Push the "Start/Pause" button
6 Finish washing
After finishing wash it'll alarm automatically
START
PAUSE
6 Push the "Air dry"button
the washing will be finished after 18 hours.