Filter
Top Products
WATER INLET SELECTOR
8
Page7
WASH
SPIN
Not set the switch to
DRAIN during washing
3
2
4
5
1
WASH TIMER
OFF
OFF
DRAIN SWITCH
OFF
DRAIN
1.Water-filling selector
1 Set the water inlet selector at the "WASH" side.
(Figure 1)
2 Set the water level adjusting lever to needed line.
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the laundries.
(Figure 4)
6.After washing, set the "WASH SELECTOR"
at "DRAIN". (Figure 5).
STANDARD
SOFT
Washing sequence
Wash timer
(To set to below 2 minutes,
first set to 6 minutes then
turn it back.).
Function selector
(Soft current,
Standard current)
DRAIN
Drain switch
DRAIN SWITCH
Spin timer
(To set to below 1 minute,
first set to 2 minutes then
turn it back. it can increase
the service life of the timer).
SPIN TIMER
Wash
Figure 1
Figure 2
Figure 3
Figure 5
FUNCTION SELECTOR
CALEFACTION
STANDARD
SOFT
FUNCTION SELECTOR
WASH TIMER
Figure 4
STANDARD
CALEFACTION
STANDARD
SOFT
(HWM80-0626S)
(HWM80-0626SH)
(HWM80-0626S)
(HWM80-0626SH)
SOFT