Haier HWM75TLA Washer User Manual


 
13
Caution: If, after completing these steps, you are unsure that unit is
properly installed, contact a qualified installer. To ensure
that your washer is properly installed, it is recommended
that it be installed by a certified installer.
3. Install the drain hose to the back of the washer using the drain hose
clamp provided. The drain hose must be placed into a drain pipe or sink
at least 3.5cm in diameter. Use the goose neck to fix the hose in place.
To avoid possible flush back of water, the drain hose must be fixed at a
minimum height of 1000mm and a maximum height of 1500mm.
4.Plug the wash er into a regular 220-240Volt/50Hz,10Amp outlet.
Note :Carefully inspect around the machine for any leaks, and tighten any
loose connecti ons.
Water Inlet
Water Supply Hose
Goose Neck
Hose Bend
Drain Hose