Filter
Top Products
14
Disposal after washing
After using, please clean the lint and foreign materials of the lint filter etc. in time.
Otherwise it may influence your using the machine.
1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).
Please first pull off the power plug from the receptacle before cleaning.
5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time
(about 1 hour), then close the top lid.
4.Hang up the power cord and drain hose.
3.Be sure to pull off the power plug before maintenance.
2.Do not store water in the washing machine for a long period. Drain the water completely after each using.
Do not decompose, repair or alter the
machine by yourself.
Do not put any hot or heavy items (such
as the kettle with hot water ) on the
washing machine.
Do not wash laundries with volatile
materials (such as thinner, petrol etc.)
The handicapped or children without
care shall not use the machine.
Keep the machine away from direct
sunlight and heat source like the heater.
Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.Do not let the children
climb the washing machine.
Petrol
Thinner
The filter screen of the water inlet valve is likely to be
blocked by foreign materials and influence the water
inlet.
Please clean it with brush every two months.
If the cabinet is dirty, wipe it with wet cloth
Do not flush it directly with water.
Wipe it with neutral detergent.
Do not wipe it with thinner, petrol, alcohol etc.
Figure 1
Install
Figure 2
Down
Dismantle
The back cover of lint filter
Install
Dismantle
Down
Up
Up
The front cover of lint filter
Lint filter:
The lint filter must be used during washing.
It must be cleaned in time after each using.
1.Push down the springpiece of the top lint filter to
make the claws out of the filter cover, andthen
pull out the lint filter toget it down. figure1
2.Pull the back of the lint filter, andthenyou canget
down itoff the front cover of the lint filter. figure2
3.Sweep the rubbishin thelint filter.
4.Put the back of the lint filter into the front cover .
5.Put the lint filter into filter cover, andmake it tight .
6.Make sure thelint filter well installed, or it can
influence your use.
Benzene
Petrol