Filter
Top Products
Front Load Washing Machine Model:HW-C1260/1460TVE/ME-U
14
(Fig1)
Error message:Temperature sensor is not properly connected or damaged (display at the end of a
program).
Troubleshooting:
N
Cut off the power and choose spin program to
start, then check the import voltage of drain
pump, is it between AC 220-240 V?
Replace drain pump
N
Cut off power and pull out water level
pressure switch wire connection. Set spin
program to start. Check the export voltage
to drain pump, is it between AC
220-240V?between blue wire and green
wire
Replace computer board
NTC exist open circuit .Replace it
Y
Y
Check if NTC is connected properly
Cut off power and measure the resistance
of temperature sensor by multimeter, is
it between 5-14kΩ?
Y
N
Connect NTC well
N
N
Replace computer board
Y
The wire between
computer board
and drain pump
is not connected
properly.
Replace the wire.
Check the blue wire and black wire of NTC, are
they connected well?
Connect all wires well
Disconnect the white wire and black wire
from computer board, and measure if the
resistance between blue wire and black wire of
PCB is it infinite?
Y
N
Y
Replace wire