Filter
Top Products
20
WATER INLET VALVE AND INLET VALVE FILTER
To prevent blockage to the water supply by ingress of foreign substances, clean the water inlet valve and
inlet valve filter regularly
.
MOVING THE MACHINE
MAINTENANCE OR SERVICE WASH
If the machine is to be moved to a distant location, replace the transportation bolts
removed before installation to prevent da
mage as
shown below
Remove the back cover1.
Remove the blanking plugs.
2.
Insert the synthetic stabilisers and the transportation bolts.3.
Tighten the bolts with a spanner .4.
Replace the back cover
.
5.
LONG PERIODS OF DISUSE
If the washing machine is left idle for a long period, pull out the electrical plug and turn off the water supply
Open the was her door to
prevent formation of moisture and odours. Let the door open while not used.
Delay
Power
Heavy
Sport wash
Quick
Spin
Wash
Rinse
Spin
Temp.
Speed
Auto
Silk
Wool
Synthetic
Memory
Cotton
Start/Pause
Pressand hold 2seconds
to set door unlocked
Delicate
Silent
Self-clean
Strongwash
Pre-wash
Soak
MANUALLY OPENING THE WASHING MACHINE DOOR
To add clothing when washing after the wash program has started or after a power cut, you want to remove the
clothing, do the following steps.
1. Make sure the level of water in drum must under the lowest edge of the door window,
2. The temperature of water is not over 50°C
3. The machine is switch off at the power supply so the drum cannot turn.
4. Disconnect the drain hose and place the open end in a bucket lower the end so that the
water in the washing machine drains out.
5. Re-connect the drain hose to the drain system.
6. Open the filter access door at the bottom of cabinet, you can see a ring pull handle. Gently pull the sprung loaded
handle down, and pull the door at the same time to open it.
7. You can add or remove the clothing. Caution, the clothing will be very wet.
8. Close the filter door.
A maintenance wash is recommended to be done to clean the washing machine out by running a high-temperature (90°C Cotton)
program. This is especially recommended if you do a significant number of low temperature washes a month. The high temperature
kills off bacteria and unwanted fungal growth. A service (or maintenance) wash involves putting the washing machine on the hottest
wash (90°C Cotton Wash) with only the detergent inside - and no laundry. If you normally use a washing machine detergent that
doesn't contain bleach, then buy some detergent that does, and use it for your maintenance washes. This will help kill off bacteria
and prevent black mould and grease. Tip: Look for something like, "bleaching agents" in the ingredients. Do not put cleaning bleach
(like Domestos) in the washing machine this will damage the machine. There are certain types of bleach example oxygen bleaches
like “Vanish” that are appropriate for laundry. To check if your washing machine is being badly affected, carefully examine the inside
of the door seal for slime. Pull the lip in front of the drum and look underneath on lip of the tub as it can accumulate a slime, which
causes smells, and rots the seal.
USING THE APPLIANCE