Filter
Top Products
0
7
BEFORE US
E
1.
1.
80 - 100 cm
2.
2.
1.
2.
INLET HOSE
1. Connect the nut on the inlet hose to the connector on the water
valve.
2. Apply inlet hose to a water tap with cold, fresh water.
Note: Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.
DRAIN HOSE
1. Use the drain hose bracket to keep the end of the drain hose
retained and prevent the outfl ow of water. Don't extend the length
of the drain hose; if an extended hose is required, please consult a
serviceman.
2. The height of the drainage outlet must be 80-100 cm. Fix the
drain hose to the clip at the back of the washing machine to prevent
it from dropping off.
Note: The drain hose should not be submerged in water and should be securely
fixed and leak-free. If the drain hose is placed on the ground or if the pipe is at
a height of less than 80cm, the washing machine will continuously drain while
being filled (self-siphoning).
CONNECTING TO THE POWER SUPPLY
Before connecting to the power supply, check:
¬ The socket is adequate for the maximum power of the washing machine
(For safety, fuses in the power circuit should be rated for no less than 15A).
¬ The voltage should meet the requirement.
¬ The power outlet should be capable of accepting the washing machine plug.
¬ Connect the machine to an earthed socket outlet.