Haier HW60-1279 Washer User Manual


 
17
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve filter regularly.
Moving the machine
If the machine is to be moved to a distant lo on, replace the transpo on bolts removed before
in
on to prevent damage as shown below.
Remove the back cover.
Remove the blanking plugs.
Insert the synthe
c stabilizers and the transpo on bolts.
Tighten the bolts with a spanner.
Replace the back cover.
Long periods of disuse
If the washing machine is l idle for a long period, pull out the electrical plug and turn off the water
supply. Open the washer door to prevent form
on of moisture and odors. Let the door open while
not used.
Display Codes
Display Codes and Special func ons
Codes Causes Solu ons
Err1 Door is not properly shut. Shut the door properly, and then press the
Start/Pause bu on.
Err2 Drainage error, water not emp within
6 minutes.
Clean the filter and check the drain hose
for blockage. If error s
l exists, please
contact the maintenance personnel.
Err3 Temperature sensor not properly
connected or damaged.
Contact the maintenance personnel.
Err4 Heater error (Appears at the end of a
cycle).
Contact the maintenance personnel.
Err5 Water level not met in 8 minutes.
The height of the drain hose is below 80
cm.
The drain hose is in water.
Make sure that tap is turned on, and water
pressure is normal.
If problem s ll exists, please contact the
maintenance personnel.
Install drain hose within 80-100 cm of
height.
Make sure the drain hose is not in water.
Maintenance
Maintenance or service wash
A maintenance wash is done to clean the washing machine out by running
a high-temperature (90°C CoƩon) program once a month. The high temperature
kills off bacteria and unwanted fungal growth. A service (or maintenance) wash involves puƫng the
washing machine on the hoƩest wash (90°C CoƩon Wash) with only the detergent inside - and no laundry.
If you normally use a washing machine detergent that doesn't contain bleach, then buy some detergent
that does, and use it for your maintenance washes. This will help kill off bacteria and prevent black mould
and grease.
Tip: Look for something like, "bleaching agents" in the ingredients. Do not put cleaning bleach (for example
“Domestos”) in the washing machine this will damage the machine. There are certain types of bleach
example oxygen bleaches like “Vanish” that are appropriate for laundry. To check if your washing machine
is being badly affected, carefully examine the inside of the door seal for slime. Pull the lip in front of the
drum and look underneath on lip of the tub as it can accumulate a slime, which causes smells, and rots
the seal.