Filter
Top Products
18
water drainage outlet should be from 80 to100cm.
2).Check whether the program is properly selected.
3).Connect the power cable to the drainage pump to check whether the operation is normal.
If not, make necessary replacement.
IV .Unusual noise
Possible causes
1.The packing screws should be disassembled.
2.The washer is placed too near a wall.
3.The washer is loaded over the standard capacity (5Kg).
4.There is foreign object other than fabrics in the washer.
5.The washer does not stand level.
6.Bolts or screws are loose.
7.The belt is loose.
Troubleshooting
1.Disassemble the packing screws.
2.Move the washer away from the wall.
3.Do not load the appliance more than the standard capacity.
4.Remove the foreign object.
5.Adjust the washer until it is level.
6.Tighten the bolts and screws.
1) .Fastening bolts of vibration damper
2) .Fastening bolts of balances
3) .Screws of water heating pipe
7.Increase the tension of belt.
V.The drum doesn't rotate; the spin speed is too high or too low.
Possible causes
1.The belt tension is too low or the fastening bolts are loose.
2.The plug wire of motor is loose or the motor is broken.
3.The capacitor is broken.
4.The PCB is broken or is not properly plugged.
Troubleshooting
1.Adjust the tension of belt and tighten the screws.
2.Check whether the plug wire of motor is loose or whether the motor works normally. If not,
make necessary replacement.
3.Check whether the capacitor is good with a universal meter. If not, make necessary
replacement.
4.Replace the PCB with a new one.
VI .The water level is too high.
Front Load Washer HMS1000TVE