Filter
Top Products
19
English
TROUBLESHOOTING
Check your problem by using the chart below (If problems occur, please pull out
the plug before examining) and try the solutions for your problem. If the dryer
still does not work properly, contact Haier customer service center or the nearest
authorized service center.
Never Overload the dryer.
Never put wet clothing washer spin cycle did not extract.
If troubleshooting is not resolved, unplug unit and call customer service.
Symptom Possible Cause Possible Remedy
Dryer won’t work No power to machine?•
Power plug not in the wall outlet?•
Front door not properly shut?•
Plug in Power Cord•
Reset circuit breaker or •
replace fuses
Close the front door •
Press in the Power/ON/
OFF or Start?Pause button
Dryer won’t heat Heating Temperature was not •
set for Timed Dry?
Is temperature indicator LED •
indicating “Air Dry”?
Outside venting ducting is •
blocked?
The exhaust filter is blocked?•
Reset the ‘Temp’ button till •
the indicator light indicates
‘High’ or ‘Low’, and the LED
is on
Change Temp. settings to •
High or Low: Air Dry works
without heat
Make sure outside vent is •
not blocked
Remove and clean Exhaust •
filter
Garments won’t dry
enough
Washer didn’t extract enough •
water?
Overloaded dryer with too •
many garments?
Clothes not sorted to proper •
cycle selection?
Make sure washer spin •
cycle is operating properly
Reduce the amount of •
garments loaded in dryer
Select the right drying cycle •
for normal, heavy or delicate
laundry loads.
Drum won’t turn (The
four indicator lights
of Cycle button are
on at the same time)
Is the front door closed?• Close front door and Press •
the Start/Pause button
WARNING!