Filter
Top Products
1Cleaning the surface
Wipe the body of the dryer and the control panel with a damp cloth.
Remember not use any organic solvent or corrosive agent to avoid
damage to the machine.
2. Cleaning the filter screen
To ensure a good ventilation during drying,
the filter screen must be cleaned after every
drying program is complete.
Open the door and remove the filter screen
from the machine. Open the screen and clean
off the dust on the screen with a damp cloth or a
After
cleaning, put the screen back in place.
3. Emptying the water collection container
During operation , steam
condenses into
water
and is collected in the
container
.
The
must
be emptied after the program is complete.
-Hold the handle and pull the container outwards to
remove it. Keep it level to prevent the water
from overflowing;
-Pour away water. Note: the
water can not be used for drink or for food
processing;
-Put the
container back in place.If the container has
been emptied, the dryer will sound an alarm
when the containeris full. The indicator light comes
on while the container is emptied and the dryer will
stop. It will not restart until the container is emptied.
4.Cleaning the condenser
The condenser must be cleaned monthly.
Switch off the power supply before cleaning.
-Hold the protrusions on both sides of the
lower decor panel and open it.
-Using a coin or other tool, push the slides on the cover to the position
as shown in the figure and then remove the cover;
-Turn the condenser's handle 90 degrees in the direction as shown in
the figure;
-Remove the condenser from the dryer;
-Clean the condenser with a brush or flush with a water jet;
Note: Do not use a sharp tool in cleaning the heat exchanger, because
it may damage its sealing performance;
-Put the condenser back in place and lock up the cover;
-Put the lower decor panel back in place.
5. Cleaning the drum
After the dryer has operated for
a time, fabric caring agents or
calcium contained in the water will
form an almost invisible layer on
the inside of the drum.
This makes the dryer not able to
reliably and accurately identify the
dryness of the laundr
y. So the inside
of the drum, especially the stainless
steel pieces on the blades must be
cleaned regularly with a wet cloth.
A
Cleaning and maintenance
Cleaning and maintenance
soft brush.
container
not
B
C
D