Filter
Top Products
16 17ECNANETNIAMECNANETNIAM
CLEANING & CARE
4.
2.
3.
1.
The condenser must be cleaned monthly. Switch off the power
supply and remove the plug before cleaning:
1. Unlock the maintenance flap and open it.
2. Screw both locking levers towards each other,Pull out the
handle/air cooler.
3. Thoroughly clean the handle/air cooler,allow all the
water to drip out,then clean the seals.
4. Re-insert the handle/air cooler,handle below,
unscrew both locking levers,close the maintenance flap
until it locks into position.
Note: Do not use a sharp tool cl
eaning the
heat exchanger, otherwise it may damage its
sealing performance.
After the tumble dryer has operated for a time, fabric caring
agents or calcium contained in the water will form an almost
invisible layer on the inside of the drum.
CLEANING THE CONDENSER
CLEANING THE DRUM
DISPLAY CODES
TROUBLESHOOTING
SNOITULOSSESUACSEDOC
F2 ¬ Drain pump error.
_
Please contact the service center.
F4
¬ Temperature of the laundry in the drum does not change.
_
Please contact the service center.
SNOITULOSSESUACMELBORP
Tumble dryer fails to
operate.
¬ Poor connection to the power supply.
¬ Power failure.
¬ No drying program is set.
¬ Device has not been switched on.
¬ The water collection tank is full.
¬ The tumble dryer door is not properly closed.
_
Check connection to the power supply.
_
Check the power supply.
_
Make sure a drying program has been set.
_
Make sure the device is switched on.
_
Empty the water collection tank.
_
Close the tumble dryer door properly.
Tumble dryer fails to oper-
ate and the displ
ay shows
"End".
by the program setting.
¬ There is no laundry in the drum.
_
Check if your program setting is appropriate.
_
Check if there's laundry in the drum.
Drying time is too long
and the results are not
satisfactory.
¬ The program setting is not correct.
¬ The condenser is blocked.
¬ The tumble dryer is overloaded.
¬ The laundry is too wet.
¬ The vent duct is blocked.
_
Make sure the program is set correctly.
_
_
Clean the condenser.
_
Reduce the amount ofl aundry in the drum.
_
Spin the laundry properly before drying.
_
Check the vent duct and unblock it.
Remaining time on the
display stops or skips.
The remaining time will be adjusted and
corrected continuously and automatically based
upon the following factors:
¬ Type of laundry.
¬ Loaded amount.
¬ The degree of spinning dry of laundry.
¬ Ambient temperature.
_
The automatic adjustment is a normal
operation.
F3 ¬
The thermal sensor(near the filter) is open-circuited or
short-circuited.
_
Please contact the service center.
DISPLAY CODES & TROUBLESHOOTING
F6
¬ The filter is full.
_
Clean the filter.
F9
¬
The thermal sensor(near the heater) is open-circuited or
short-circuited.
_
Please contact the service center.