Filter
Top Products
Installation
4
Fig 1
As shown in figure1 remove all the packing materials
(including the foam base).
Remove the packing screws as shown in figure 2.
The packing bolts protect the appliance from shock during
transportation The steps below should be followed before
using the appliance,
1. Remove the rear panel of the washing machine;
2. remove the three packing bolts from the rear panel of the
washing machine,the rubber hose and then the shock ab-
sorption channel steel;
3. reinstall the back plate;
4. fill the holes left by the packing bolts with plastic plugs.
(Attention: the packing bolts and rubber hose should be kept
in a safe place for later use)
Fig 2
Adjusting the position of the washing machine .There are
adjustable feet under the bottom of the washing machine. Be-
fore use, the washing machine should be adjusted, as shown in
figure 3, so that it is level.
Fig 3
4