Filter
Top Products
Using Method
6. Do not take the laundry out until drying process is done
The last 20 minutes of hot air drying is cooling
to reduce the temperature of laundry inside
the drum.
To take the laundry out during drying, please
run cooling operation first since the temperature
inside the drum must be high.
Static electricity, due to friction, will be
generated on clothes made of chemical fibre
after dried. You can feel it when taking them out,
which is normal and shall not to be worried about.
7. Unplug the power cord
Please hold plug to unplug power cord from
a receptacle. Do not pull electrical wire directly
to prevent internal breakage or bad connection.
8. Clean filters
Clean the lint filter after every load and before each use. A clean filter ensures
sufficient drying. A layer of lint on the filter reduces airflow through the clothes
and prolongs drying time
5. Dry time settings
Please refer to page 8 ' Control panel and its functions'
and page 10 ' Dry Capacity Dry Time Reference Table' .
4. Set 'heat selector knob' to select 'Strong
dry' or 'Soft dry' level.
'Strong dry' level for large quantity and low room temperature.
' Soft dry' for non heat-resistant clothes.
Soft
Heat selector knob
Select dry program according to clothes materials and
quantity, turn the timer knob to relative position. The
dryer starts running.
Strong
Caution: Dry timing knob cursor
shouldn't be set at the blank area,
as indicated in the right figure.
Do not
point the
cursor to
blank
OFF
OFF
Air dryingAir drying
CoolingCooling
0
0
60
40
20
220
200
180
160
140
120
100
80
60
40
20
Do not point the
cursor to blank.
Refer to the instructions on page 11.
Drying time(min)
Strong dryStrong dry
Regular dryRegular dry