Filter
Top Products
8
Washing sequence
8
4
3
2
1
5
SPIN TIMER
WASH SELECTOR
Install the water inlet hose; Select the water level
Select water level according to the
quantity of the laundries.
Set the water level adjusting lever
to needed line.
Insert the water inlet hose into the water-filling
entrance on the control panel directly.(pull it
out to dismantle it)
Use the new water inlet hose provided
with the machine to connect to the
water faucet.Old hose sets should
not be reused.
5
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation
position of the drain hose.
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Take the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the
side of the spin tub in the order of (1)~(3), heading
for the side of the spin tub. (See to Figure 3).
Embed the drain hose into the groove with
hands. Take care not to damage the drain
hose in fastening the fixing clamp.
Figure 1
Extend the drain hose from the side of spin tub
Figure 3
Embed into the
groove in turn
Extend to the
spin tub side
Soft item
Back
Front
Figure 2
Soft item
Water inlet hose
Water inlet
Maximum
Max
Minimum
Min
Medium
Med
Water level
indicator
DRAIN SELECTOR
Spin timer
(To set to below 1 minute,
first set to 2 minute then
turn it back. it can increase
the service life of the timer).
Wash selector
(Standard current,
strong current)
Drain selector
(Do not set drain selector
on Drain position during
washing)
Water inlet
Water filling
control handle
WASH
SPIN
WASH TIMER
Wash timer
(To set to below 2 minute,
first set to 5 minute then
turn it back. it can increase
the service life of the timer).
OFF
OFF
12
12
9
6
3
15
15
STANDARD
STANDARD
STRONG
STRONG
DRAIN
DRAIN
OF
F
OF
F
OF
F
OF
F
STANDARD
STANDARD
STRONG
STRONG
Wash
Figure 5
Figure 4
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the
laundries. (Figure 4)
6.After washing,the buzzer will ring .Set
the "DRAIN SELECTOR" at "DRAIN".
(Figure 5).
Figure 3
Figure 2
O
FF
OF
F
12
9
6
3
15
DRAIN
DRAIN
1 Inlet selector
(1) Set inlet selector to Wash side. Figure 1
(2 )Adjust water level rod to a position as needed.
WASH
SPIN
Figure 1
O
FF
OFF