Filter
Top Products
The numbers in the illustration correspond to steps.
5. Using the blade end of a putty knife covered with
masking tape, carefully remove the hole plugs located
in the bottom of the dryer front panel.
6. Remove the 4 legs from the dryer base.
7. Place the dryer on top of the washer. Slide the dryer
back into the rear brackets (7A) then drop the front
down over the front brackets (7B).
Stacking Instructions–Reversing Door Swing
20
REVERSING THE DRYER
DOOR SWING
1. Open the dryer door. Remove the 4 hinge hole plugs or
screws from the left side of door opening. Place nearby
for future installation. NOTE: You may need a plastic knife
to help pull out the plugs. Be careful not to scratch the paint.
2. Remove the four screws that secure the door hinges to
the dryer front panel. NOTE: Remove 1 screw from each
of the 2 hinges first. Hold the door firmly before removing the
last 2 screws.
3. Rotate the door 180° and reinstall the door hinges to the
dryer front panel with the 4 screws.
4. Install the 4 hinge hole plugs or screws that were
removed in step 1 into the open screw holes on the right
side of the door opening.
Remove 4 screws—one from each hinge first
8. Insert the 2 long screws provided in the kit through
the holes in the dryer front panel and install into the
front mounting brackets.
9. Install the hole plugs removed in step 5.
10. Refer to the washer and dryer installation instructions
for proper installation and function.
11. Save the top panel and brackets in the case of future
side-by-side use.