GE WWP1170F Washer User Manual


 
red button on the side of the
adapter. At the end of the wash
cycle turn off faucets, press red
button again to relieve pressure
and eliminate splashing. Do not
disconnect hose coupler until
pressure is relieved.
Set wash temperature at faucet.
Washer drains into sink. Be sure
sink drain is open to prevent
overflowing. Blend hot and cold
water in equal parts for WARM
WASH. After wash agitation has
started, change faucet settings for
your rinse water temperature. Be
sure to plug washer into a properly-
grounded three-prong receptacle.
See your Installation Instructions.
~ Push Cycle Selector in and turn
clockwise to your selected wash
cycle.
Pull Cycle Selector out to start
the cycle. If you wish to change
cycle setting after washer has
started, push Cycle Selector in
and wait for washer to stop. Then
reset to the new position. Setting
can be changed at any time during
the cycle.
HUNVto soak h Yew’washer
Set WASH/RINSE TEMPERATURE
at WARfWWARfvl(MANUAL) and
adjust faucets for desired soak
temperature. Add detergent or
soak agent. Turn Cycle Selector to
desired cycle. Start the washer.
After washer fills and begins to
agitate, push in the Cycle Selector
to stop washer. Allow to soak for
as long as desired. After desired
soak, turn to the last Spin. Pull
out the Cycle Seiector to complete
the cycle.
controls setting‘(3LMC!
Some adjustment to these recommendations may be desirable depending on your particular washing conditions.
Cottons & Linens
Permanent Press
Polyester Knits
Synthetics & Wends
Work clothes,
Work clothes,
Fabric
dungarees, etc. dungarees, etc.
White or Bright
Heavy or Normal or Heavyor Normal or
with heavy soil with normal soil
Colorfast Colors
Oily Soil Light Soil
Oily Soil
Light Soil
Wash/Rinse
Hot/Cold
Hot/Cold or HotlCold or
Cold/Cold
Temperature’
Warm/Cold Warm/Cold
Hot/Cold Warm/Cold
Warm/Cold Warm/Cold
Cycle
Regular Regular Regular
Regular
Perm, Press Perm. Press
Delicate Delicate
Cycle Selector
,5
Setting
15 15
10
12
8 Start Start
*For
portable, set at Warm/Warm (Manual) and leave it there.