Filter
Top Products
How to use the
How touse the
Filter-FW Pan
Soak Cycle
-1
Regular Cycles
sMkCvcle .0
‘ r-
080g
AuTOEXTRARINSE
EJ
. uSOAK CYCLE’> temperature
will automatically be cold.
● If a hot or warm soak is desired, set
the WWH/RINSE TEMPERATURE
switch to “HOT/COLD” or
“WARM/COLD” and turn the
Cycle Selector Knob to “Normal”
in the Regular Cycles. Start the
washer. After washer fills and
begins to agitate, push in the Cycle
Selector Knob and turn to “SOAK
CYCLE:’ Pull out the Cycle
Selector Knob to complete the cycle.
● For an extended soak, allow the
washer to fill and agitate for a few
minutes to dissolve the soaking
agent. Then push in the Cycle
Selector Knob to stop the washer
The Filter-Flo pan is the lint filter.
Position the Filter-Flo pan on the
agitator after loading clothes into
the washer. Lint is easily seen and
removed after the wash is finished.
(keep lid closed) and allow to soak
NOI’E: Do not use the Filter-Flo
for as long as desired. Afler desired
pan as a wash basket. Do not put any
soak period, pull out the Cycle
Selector Knob to complete the
items to be washed in the Filter-Flo
pan. Do not place detergent packets
cycle.
in the Filter-Flo pan.
Eneqgy-SavingTips
If your clothes and household items
don’t look clean and fresh after
washing, you will probably re-wash
them.. and that means you’ll waste
energy. Remember to sort your
clothes carefully, and load them
properly, select correct cycles, use
enough detergent and choose a
water tempemture warm enough to
release and get rid of soil.
● Use Hot Wash—upto 150°F.-on
a regular basis only when washing
heavily soiled articles-such as
work and play clothes.
● Under normal soil conditions,
wash in water above 80”F. (Z7”C.).
This generally means using the
W-Wash temperature setting on
your washer-temperatures
approximate y 90° to llO°F.or hand
comfortable. If you notice that soil
has accumulated after several
consecutivewashings,use Hot Wxh
occasional y, if safe for fabrics.
● Try to wash less often. Save
articles of the same type of fabric
until you have a full load.
● If you must wash smaller loads,
adjust the amount of water. Small
loads should have lower water
levels.
● Washin off-peak utility hours.
Yourlocal utility can tell you which
are the off-peak hours.