Filter
Top Products
PROBLEM
WA~R
WON’T
DRMN
WA~R
LEAKS
WASHER IS NOISY
WASHER PAUSES
IN CYCLE
POSSIBLE CAUSE
* Make
sure
drain hose is not kinked.
●
Top of drain outlet should be less than 8 ft. (2.4 m) above floor.
●
Make
sure hose connections are tight at faucets.
●
Make sure end of drain hose is
correcdy
inserted in and secured to drain facility.
●
Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Installation Instructions.
●
A sharp, distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission “locks in.” This sound is normal.
. When using the
SPOTSCRUBBER Cycle,
a sharp distinctive sound will be heard soon
after agitation begins. This is the sound of the water recirculation system cutting off
to keep
tie
concentrated detergent solution in the Mini-Basket tub.
●
Heavily unbalanced loads can cause
tie
washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases
(usuNly
occurs
when washing a single, heavy item or a small load when water level is set higher
than necessary), the spin basket may strike the outer tub, creating a loud but harmless
noise. To correct, open the lid and redistribute the load evenly about the wash basket.
Close the lid and restart.
●
Washer
norrrudly
pauses between washing steps.
..such
as between wash and spin or
between
s~in
and rinse.
If you need more help.. call, toll free
GE Answer
Center@
800.626.2000
consumer information service
29
—