Filter
Top Products
PROBLEM
WASHER IS NOISY
WASHER PAUSES
IN CYCLE
POSSIBLE CAUSE
●
Make sure washer is level
and
firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Instigation Instructions.
●
A sharp, distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission “locks in.” This sound is normal.
●
Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary), the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, stop the washer by pushing in the Cycle Selector knob, open the lid and
redistribute
tie
load
evenly
about the wash basket. Close the lid and restart.
. Washer normally pauses between washing steps... such as between wash and spin or
between spin and rinse.
If you need more help...call, toll free: GE Answer Center
@
/ 800.626.2000/consumer information service
CAW
Am
CLEAN~G
USER MAINTENANCE INSTRUCTIONS
The
~b.
The porcelain is self-cleaning. Leave lid
To Store Washer.
Ask service technician to remove
open after washing to allow moisture to evaporate.
water from drain pump and hoses to prevent freezing.
Do not use harsh or gritty cleansers.
Do not store the washer where it will be exposed
The Exterior.
Wipe off any spills of washing
to the weather.
compounds. Wipe or dust with damp cloth. Try
For Long Vacations.
Be sure water supply is shut off
not to hit surface with sharp objects.
at faucets and drain all water from hoses if weather
will be below freezing.
How to remove the agitator
To remove the agitator,
snap the cap off and remove
the screw. Then remove
the agitator extender (on
models so equipped)
and the agitator.
To replace the agitator,
carefully lower it straight
down onto the shaft so
that it fits snugly into
place. Replace the agitator
extender (on models so
equipped), the screw
and the cap.
—
Cap
*—
i–
Screw
Agitator
Extender
A
(on some models)
— Agitator
))
/
.,
!
—
Shafl
(Appearance may vary)
To remove limestone from
Filter-Flo
pan
● Soak filter pan in a preheated
160°F.
(71 ‘C.)
solution of
hdf
vinegar and half water for 15
minutes. Then brush each side of pan with a stiff
bristle brush while flushing with running water.
CAUTIONS:
● Do not soak in porcelain container. Vinegar
can damage porcelain.
● Do not exceed
180°F.
(82°C.
) or filter pan
may warp.
21