Filter
Top Products
PROBLEM
SNAGS, HOLES
TEARS, RIPS OR
EXCESSIVE WEAR
(continued)
HEAVILY SOILED
AREAS
such
as
collars
and
CUffS
WASHER WON’T
OPERATE
WATER
TEMPEWTU~
IS INCORRECT
WATER WON’T
DRAIN
POSSIBLE CAUSE
● Chemicals such as hair bleach, dye, permanent wave solutions, battery acids and
toilet bowl cleaners may cause fabric holes. Rinse all towels and other articles that
came in contact with these chemicals before putting them in wash. Do not
contaminate clothing articles with these chemicals.
● As Permanent Press garments age, they may show fraying at collars and cuffs. This is
normal due to weakening of fibers by the Permanent Press process. It is not caused
by washer. You can slow this process by washing small Permanent Press loads with
a Large Water Level. Do not wash heavy items such as
towels
with Permanent Press.
Remove collar stays, when possible.
● Roughness or burrs on agitator may cause rips or tears. Check agitator and file rough
spots if necessary.
● May be caused by the use of Regular
Cycles
for delicate articles. Use
Perm.
Press
cycle. Refer to Garment Manufacturer’s Care Labels.
● Garments weakened by age, sun or atmosphere. This is inevitable and is not caused
by washer.
● Too large loads, or too little water. Load washer only with number of items that will
move freely. Select correct water level.
Pretreat with liquid detergent. Use Extra Cleaning cycle, see Tips to Help You Select
Settings section.
@@@@
s
M&e sure cord is plugged into outlet.
● Make sure both hot and cold faucets are turned on.
● Make sure controls are set and Cycle Selector knob is pulled out to ON position.
● Make sure lid is closed. Washer will fill but
will
not spin or agitate with lid open.
● Check house fuses or circuit breakers. If another appliance is sharing the electrical
outlet, remove it. Washer should have separate outlet.
● Make sure temperature selector controls are correctly set.
● Make sure hot and cold faucets are turned on and
regulated correctly.
●
Make sure hoses are connected to correct faucets . . .
hot to hot, cold to cold.
● Water valve screens may be stopped up. Remove inlet
o
+
5?
hoses from water
valve.
Clean the screens and reinstall hoses.
● Check house water heater to make sure it is delivering water at
140°F.–1500F.
(60°C.-650C.).
“
Make sure drain hose is not kinked.
● Top of drain outlet should be less than
8
ft. (2.4 m) above floor.
● Make sure hose connections are tight at faucets.
● Make sure end of drain hose is correctly inserted in and secured to drain facility.
WATER LEAKS
(<[)nfinuf’d
next
p{lge)
25