GE WWA8816R Washer User Manual


 
T~
PROBLEM SOLVER
(continued)
PROBLEM POSSIBLE CAUSE
WASHER IS NOISY
Make sure washer is level and firm to the floor with rubber foot
pads in place and front jam nuts tight. See your Installation Instructions.
A sharp, distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission locks in. This sound is
norrnd.
Heavily unbalanced loads can cause
the
washer to vibrate excessively during
spin, and may cause it to move from its original position. In extreme cases
(usually occurs when washing a single, heavy item or a small load in a tub full
of water), the spin basket may strike the outer tub, creating a loud but
h@ess
noise. To correct, open the lid and redistribute the load evenly about the wash
basket. Close the lid and restart.
WASHER PAUSES
Washer
norrndly
pauses between washing
steps.. such as between wash and
IN CYCLE spin or between spin and rinse.
If you need more help... call, toll free: GE Answer Center
@
/ 800.626.2000/ consumer information service
CARE
Am
CLEAN~G
USER MAINTENANCE INSTRUCTIONS
The
~b.
The
pdcelain
is self-cleaning. Leave lid
To Store Washer.
Ask service technician to remove
open after washing to allow moisture to evaporate. water from drain pump and hoses to prevent freezing.
Do not use harsh or gritty cleansers.
Do not store the washer where it will be exposed
The Exterior.
Wipe off any spills of washing to the weather.
compounds. Wipe or dust with damp cloth. Try
For Long Vacations.
Be sure water supply is shut off
not to hit surface with sharp objects.
at faucets and drain all water from hoses if weather
will be below freezing.
How to remove the agitator
To remove the agitator,
snap the cap off and remove
~
Cap
the screw. Then remove
the agitator extender (on
o
Screw
~,
=
Agitator
Extender
models so equipped)
and the agitator.
A
(on some models)
To replace the agitator,
~
,
Agitator
caref~lly lower it-straight
down onto the shaft so
that it fits snugly into
c>
//’j
,
place. Replace the agitator
extender
(on
models so
equipped), the screw
i
Shafi
and the cap.
(Appearance may
va~)
To remove limestone from
Filter-Flo
pan
Soak filter pan in a preheated
160°F.
(71°C.)
solution of half vinegar and half water for 15
minutes. Then brush each side of pan with a stiff
bristle brush while flushing with running water.
CAUTIONS:
Do not soak in porcelain container. Vinegar
can damage porcelain.
Do not exceed
180°F.
(82°C.)
or filter pan
may warp.
26