Filter
Top Products
HOW TO OPERATE YOUR WASHER
WARNING—To reduce the risk of fire, electric shock, or injury to persons,
read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
Delicate
Regular
OFF
RINSE
SPIN
OFF
RINSE
SPIN
OFF
START
RINSE
SPIN
Perm Press
PULL TO
START-PUSH
TO STOP
15
10
5
12
4
8
Water LevelWash Temperature
HIGH
MED
LOW
WARM
COLD
HOT
1
2
3
Set the controls
See the Controls Setting Guide.
Select Wash Temperature. Cold rinse will be
automatically provided with all cycles.
Select Water Level.
LOW: Washer is less than 1/3 full of clothes.
MED: Between 1/3 and 2/3 full.
HIGH: Over 2/3 full of clothes.
Push Cycle Selector in and turn clockwise to
your selected wash cycle.
Pull Cycle Selector out to start the cycle.
NOTE: If you wish to change cycle setting after
washer has started, push Cycle Selector in and wait
for washer to stop. Then reset to the new position.
Setting can be changed at any time during the
Regular, Perm Press or Delicate cycles.
4
1
2
3
4
Self-cleaning lint filter
The lint filter needs no attention from you. Lint collected during
washing and rinsing of clothes is automatically flushed down
the drain.
How to soak in the washer
Set wash temperature control. Add detergent or soak agent. Turn Cycle Selector to
desired cycle. Start the washer. After washer fills and begins to agitate, push in the Cycle
Selector to stop washer. Allow to soak, turn to Spin. Pull out the Cycle Selector to complete the cycle.
Delicate Cycle
To get the full benefit of the Delicate Cycle, always
set the Cycle Selector at the beginning of the cycle.
During wash, the Delicate Cycle alternates between
agitation and pause, to protect delicate clothes.
Delicate
OFF
START
RINSE
SPIN
15
10
5
8