Filter
Top Products
,'##M$'%'$'"#
)(-*()#()!!)$#(*')$
($##))'.''$")(!)'!
(*%%!.%'$)).$*'#(#'"(
'$"('%(,#,$' ##(
)#)(*')$,'!$+(
=BC0;;0C8>==BCAD2C8>=B
(+#)#
AH4AG70DBCC>A867C>52018=4C5>A;42CA82
<>34;B>=;H
AH4AG70DBCC>;45C>52018=4C5>A0B0=3
;42CA82<>34;B
Detach and remove the bottom, right or left side
knockout as desired. Remove the screw inside the
dryer exhaust duct and save. Pull the duct out of
the dryer.
Remove
screw
and save
Remove desired
knockout (one only)
Fixing hole
Cut the duct as shown and keep portion A.
)!$)$#
Bend tab
up 45°
Through the rear opening, locate the tab in the
middle of the appliance base. Lift the tab to about
45°,using a flat-blade screwdriver.
##,*)
Reconnect the cut portion (A) of the duct to the
blower housing. Make sure that the shortened duct
is aligned with the tab in the base. Use the screw
saved previously to secure the duct in place
through the tab on the appliance base.
#!$,#*)$'-*()
)$!)$'')($#)
K Insert the 4″ elbow through the rear opening and
connect the elbow to the dryer internal duct.
K Insert the 4″ duct through the side opening
and connect it to the elbow.
*)$#>=>C?D;;>A30<064C74
4;42CA820;F8A4B0=33>=>CA4<>E4C74E8=H;2>E4A
5A><C744;42CA820;2><?>=4=CB8=B834C743AH4A
F74=8=B4AC8=6C743D2CB;867C8=C4A54A4=24
<0H>22DA14CF44=C744G70DBC0=3C74F8A4
2><?>=4=CB
Portion “A”
Left side
exhaust
Fixing hole
Internal duct
Not for gas
A
13
1
⁄2″
Right
Left
Bottom
Rear opening
Side opening