Filter
Top Products
Using the four shipping carton corner posts
(two on each side), carefully lay the dryer on its
left side and remove foam shipping pad.
CAUTION:
To prevent damage, do not use the
control panel as a means to pick up or move
the dryer.
Return the dryer to an upright position.
Adjust the leveling legs to match the washer
height. The dryer must be level and rest firmly
on all four leveling legs.
3
2
1
10
Preparing to install your dryer.
Read these instructions completely and carefully.
Customer Service Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
WARNING
■ This dryer must be exhausted to the outdoors
using only rigid metal or flexible metal 4″
diameter ductwork for inside the dryer cabinet
or exhausting.
■
Never use plastic or other combustible ductwork.
See Exhausting section.
■ This appliance must be properly grounded
and installed as described in these
Installation
Instructions.
■ Do not install or store appliance in an area where
it will be exposed to water/weather. See
Location
of Your Dryer
section.
■ The National Fuel Gas code restricts installations
of
gas appliances
in garages. They must be 18″
(45.7 cm) off the ground and protected from
vehicles by a barrier. See
Location of Your Dryer
section.
■ The
electrical service
to the dryer must conform
with local codes and ordinances and the latest
edition of the National Electrical Code,
ANSI/NFPA 70.
■ The
gas service
to the dryer must conform with
local codes and ordinances or the latest edition of
the National Fuel Gas Code ANSI Z223.1.The gas
dryer is designed under ANSI Z 21.5.1 for
home
use only
. This dryer is not recommended for
commercial applications such as restaurants or
beauty salons, etc.
Unpacking the Dryer
Foam shipping pad
Packing
■ Phillips head screwdriver
■ Channel-lock adjustable pliers
■ Carpenter’s level
■ Flat or straight blade screwdriver
■ Duct tape
■ Rigid or flexible metal 4″ (10.2cm) duct
■ Vent hood
■ Pipe thread sealer (
GAS DRYER
)
■ Plastic knife
■ 1/2″ open-end wrench
Tools and Materials Required for Dryer Installation