Filter
Top Products
6
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
Fabric Care
COTTONS For regular to heavy cottons.
REG. HEAT
EASY CARE For synthetics, blends, delicates and items labeled
permanent press.
MED. HEAT
FLUFF For
fluffing
items without heat. Use the
TIMED DRY
cycle.
NO HEAT
DELICATES For delicates, synthetics and items labeled
tumble dry low.
LOW HEAT
Drying Cycles
— Automatic cycles automatically determine fabric dryness. Select
LESS DRY
if you want
your clothes slightly damp at the end of the drying cycle. Select
MORE DRY
if you
want them to feel drier. Timed cycles run for the selected time.
COTTONS For cottons and most linens. For most loads select
OPTIMUM DRY
.
EASY CARE For wrinkle-free, permanent press and delicate items, and knits.
DELICATES For delicate items, special-care fabrics and knits.
TIMED DRY Set the Cycle Selector at the desired drying time.
DAMP DRY For leaving items partially damp.
DEWRINKLE For removing wrinkles from items that are clean and dry or that are very lightly damp.
QUICK FLUFF For freshening or fluffing up already dry clothing, fabric, linens and pillows. Use with
FLUFF NO HEAT
.
Provides 10 minutes of no-heat tumbling.
Start
— Close the dryer door. Select
START.
Opening the door during operation will stop the dryer.
To restart the dryer, close the door and select
START
to complete the cycle.
NOTE: Drying times will vary according to the type of heat used (Electric, Natural or LP gas),
size of load, types of fabrics, wetness of clothes and condition of exhaust ducts.
3
2
1
About the control settings.
IMPORTANT: Clean the lint filter each time you use the dryer.
Color Logic
Select the correct
FABRIC CARE
setting.
Match the particular color below the words
with the same color on the Cycle Dial.
Example: Drying a load of clothing labeled
permanent press.
Choose the
FABRIC CARE
setting
-—for
this load it would be the
EASY CARE
MED. HEAT
(which is a particular color).
Turn the Cycle Dial to the area that has
the same color as the
FABRIC CARE
setting you have chosen—for this load
it would be the
EASY CARE AUTOMATIC.
2
1