GE DSKP233ET Clothes Dryer User Manual


 
Spacemaker Dryer
Push To Start
ENERGY PREFERRED
AUTOMATIC SETTING
O
F
F
O
F
F
O
F
F
L
E
S
S
M
O
R
E
A
I
R
15
30
45
60
75
90
105
10
T
I
M
E
D
D
R
Y
I
N
G
P
E
R
M
.
P
R
E
S
S
/
R
E
G
.
1
2
WARNING—To reduce the risk of fire, electric shock, or injury to persons,
read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
Check the Lint Filter
HOW TO OPERATE YOUR DRYER
6
Clean the lint filter each time the dryer is used. Always
be sure the lint filter is in place.
Do not run the dryer with the lint screen
loose, damaged, blocked or missing. Doing so
can cause overheating, damage fabrics and be a
fire hazard.
The lint screen is located inside
the dryer drum, on the back wall.
To clean:
1. Use the finger holes to pull the lint
screen straight out.
2. Lightly squeeze the body as shown
while pulling the cover off.
3. ROLL lint off the screen with
your fingers. Do not rinse or
wash the screen.
4. Replace the cover on the body of
the lint screen.
5. Before replacing the lint screen,
remove any lint from the wire mesh
on the back wall (behind the lint screen).
6. Push the lint screen straight back until it snaps
into place.
Sort and Load the Clothes
Good sorting for the dryer begins at the washer.
Generally, if clothes are sorted right for washing,
they’re sorted right for drying. See the How to Sort
the Clothes section.
If you do mix various types of fabrics in your load,
set the controls for the lighter-weight fabrics and
remove when dry. Reset controls for the remaining
heavier fabrics
Set the Controls
NOTE: Drying times will vary according to the type of heat used (electric,
natural gas or LP gas), size of load, types of fabrics, wetness of clothes and
condition of exhaust ducts.
See the Suggested Fabric and Drying Selections guide.
Cycle Selector.
Turn the Cycle Selector to the desired cycle setting.
The selector may be turned in either direction.
Start Button.
Press the Start button to start the dryer. (Opening
the door during operation stops the dryer. To
restart, close the door and press the Start button.)
2
1
Squeeze body;
pull cover off
Pull straight out