GE DPSR513 Clothes Dryer User Manual


 
About your dryer features.
End of Cycle Signal
This signal will sound just before the end of the
cycle to remind you to remove the clothes.
If you selected the
WRINKLE CARE
option
the signal will sound at the end of the drying
time and will sound several times during the
WRINKLE CARE
cycle. This will remind you that
it is time to remove the clothes.
NOTE:
Remove garments promptly at the sound
of the signal. Place clothes on hangers
so wrinkles won’t set in.
Use the END OF CYCLE SIGNAL especially
when drying fabrics like polyester knits and
permanent press. These fabrics should
be removed so wrinkles won’t set in.
E
L
E ELECTRONIC TONE
SIGNAL
OFF
ON
Drum Lamp
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the circuit
breaker. Reach above dryer
opening from inside
the drum. Remove the
bulb and replace with the
same size bulb.
Drying Rack
A handy drying rack may be used for drying
articles such as stuffed toys, pillows or washable
sweaters.
Hook the rack over the lint filter so the rack
extends into the dryer drum.
NOTE:
The drying rack must be used with the
TIMED CYCLE.
Do not use this drying rack when there are
other clothes in the dryer.
Wrinkle Care
Use this option to minimize the wrinkles in
clothes. It provides approximately 15 minutes
of no-heat tumbling after the clothes are dry.
This option can only be used with the
Automatic cycles.If you are using the
CYCLE
SIGNAL
and you select the
WRINKLE CARE
option,
a signal will sound at the end of the drying time
and several times during the
WRINKLE CARE
cycle.
This will remind you that it is time to remove the
clothes.
If
WRINKLE CARE
is not
ON,
the dryer will stop
once the timer reaches the
WRINKLE CARE
mark
on the cycle dial.
A
RE
A
T
WRINKLE CARE
EXTENDED COOL AIR TUMBLE
OFF
ON
SensorDry
This feature is only activated in the
automatic cycles.
SensorDry
provides greater drying accuracy
than standard machines, resulting in shorter
dry times and better clothes care. As the
clothes tumble, they touch a moisture sensor.
The sensor will stop the heating cycle as soon as
the clothes have reached the selected dryness.
On some models, there is a
Dryness Sensor
Cycle
indicator light. This light is illuminated
during automatic cycles. When the
SensorDry
feature stops the heating cycle, the light will
go out and the cool down period will begin.
Note:
The clothes will be hot if they are
removed immediately after the indicator
light goes out.
SensorDry