Filter
Top Products
~F.brie Care Selections
Push a button to select the proper heat for
your load.
Should be used with cycles indicated ●
Automatic,
Fabric Care
Automatic
Perm Press and
Timed
Selections
Regular Cycle
Knits Cycles
Cycles
Cottons
Hiah
Heat
●
●
I
Perm Press
Medium Heat
●
●
Knits/Delicates
Low Heat
●
●
Fluff
No Heat
●
~
Extra Care Cycle
@
Select End of Cycle Signal, if
(Operates only with Automatic,
desired. (See below. )
Perm Press& Knits Cycles. )
~
Turn Cycle Selector to desired
//’
Turn to ON if desired. To minimize
cycle setting. The selector may be
wrinkles set in the clothes, the Extra
Care cycle provides approximately
turned in either direction.
15 minutes of no-heat tumbling
~
Press PUSH TO START button
after the clothes are dry.
to start dryer. (Opening the door
Use End-of-Cycle Signal. Signal
during operation stops
the dryer. To
will sound at five-minute intervals
re-start, close the door and press
to remind you to remove the clothes.
the START button. )
End-of-Cycle Signal
(Operates with any cycle.)
I
MED
The Signal control can be set
anywhere between OFF and
LOUD, depending on desired
sound level. The signal will sound
just before the end of the cycle to
remind you to remove the clothes.
To stop signal while sounding, turn
Signal control to OFF or advance
Cycle Selector to OFF.
The Signal should always be used
when drying Polyester Knits or
Permanent Press items which
should
be removed as soon as the
dryer stops to help prevent setting
of wrinkles.
The signal should also be used with
the Extra Care Cycle.
Polyester Knits &
Permanent Press
drying tips
● DO NOT
OVERLOAD—
Garments being dried or
dewrinkled should tumble freely.
● REMOVE CLOTHES
PROM~LY—To help prevent
wrinkling, remove from the dryer
promptly at the end of the drying
cycles.
● PLACE ON
HANGERS—
Permanent Press and Polyester
Knit garments look best if placed
on hangers after drying.
5
What is the difference
between Mined &
Automatic drying?
Timed Drying
When using the TIMED CYCLES,
you select the number of minutes
you wish the dryer to run and it
turns off at the end of this time
period.
Automatic Drying
When using the Automatic Cycles,
the Electronic Sensor
Control
.p:~
system
continually senses the
~..
L(
~~
“Wel%e@
determines when they a;e dried to
your pre-selected setting, and
terminates the cycle automatically.
Refer to the CONTROLS SETTING
GUIDE for recommended settings.
The Cycle Selector will not advance
until clothes have reached a certain
degree of dryness.
Dryness selections guide for
the automatic cycles
Set to Middle Position
,,,
s
OFF
,,”
.
● For most normal loads
Set toward MORE DRY
● For loads that include heavy-
weight fabrics.
● If you desire to remove more
moisture.
Set toward LESS DRY
● For lightweight fabric loads.
● If you desire to remove less
moisture.
● For very small loads.
—