Filter
Top Products
Problem Possible Causes What to Do
O_rd_/mg
No fabric softener was used
Synthetics, permanent press
and blends can cause static
• T.ry a fabric softener.
• .Adjust controls ff,r less drying.
• 'Try a fabric softener.
• Try a fabric softener.
Improper sorting • Separate heavy items from lightweight items
(generally, a weTl-sorted washer load is a
well-sorted dpcec load).
Large loads of heavy items • Large, hea D, lo_._.dscontain more moisture
(like beach towels) and take longer to dry. Separate large, heavy
items into smaller loads to speed drying time.
Controls improperly set • Match control s,ettings to the load you
axe drying.
Lint Filter is full • Clean lint filter before every load.
Improper or obstructed
ducting
Blown fuses or tripped
circuit breakers
Overloading/
combining loads
Underloading
• Check installation instructions for proper
ducfing/venting.
• Make sure ductmg is clean, free of kinks
and unobstructed.
• Check to see if outside wall damper
operates easily.
° See the Venting; the Dryer section.
• Replace fuses or reset circuit breakers. Since
most dryers use 2 fuses/breakers, make sure
ooth are operaling.
• Do not put more than one washer load in
the dryer at a time.
• ffyou are drying only one or two items,
add a few items to ensure proper tumbling.
16