Filter
Top Products
Stacking.
4. Prepare the Washer and Dryer
A. Place the washer in the
approximate location.
B. Make sure the washer is level.
Refer to washer Installation
Instructions for details.
C. Remove the back portion of
the control panel by removing
the 3 screws.
D. Reverse dryer door swing if
desired. See dryer Installation
Instructions for details.
NOTE: The washer door swing is not
reversible.
INSTALLING THE STACK BRACKET KIT (cont.)
5. Install Dryer and Bracket
on Washer
A. Lift the dryer on top of the
washer. Be careful not to scratch
the top of the washer with the
brackets. Protect the washer
control panel with cardboard or
other protection. Be sure to lift
the dryer high enough to clear
the washer control panel.
WARNING!
Potential Personal Injury. More than
two people are recommended to lift the
dryer into position because of its weight
and size. Failure to do so could result in
personal injury or death.
B. Align the holes in the bracket
with the holes in the back of the
washer. Using a Phillips screwdriver
attach the 2 #8 x 1/2″ tapping
screws. Repeat on both sides
of the washer.
6. Finalize the Installation
A. Refer to the washer Installation
Instructions to complete the
washer installation.
B. Refer to the dryer Installation
Instructions to complete the dryer
installation.
C. Carefully slide or walk the stacked
washer and dryer into place. Use
felt pads or other sliding device
to assist moving and to protect
flooring.
WARNING!
Potential Personal Injury. Do not push
on the dryer once installed to top of the
washer. Pushing on the dryer may result
in pinched fingers.
Place
hands
here
Place
hands
here
22
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips