Filter
Top Products
Other
dqe~features
your model has
●
Standard #2 Phillips screwdriver
●
Tape-tippedpu~
knife
●
Needle-nosed pliers
1
2
Open the door and remove the
filler plugs opposite the hinges.
With the door completely open,
remove the bottom screw from
each hinge on the
d~er
face.
3
4
5
10
Insert these screws about ha~way
into the TOP holes, for each hinge,
on the opposite side. (Where you
removed the filler plugs.) Apply
firm
pressure to get the screw
started in untapped holes.
Loosen the top screw from each
hinge on the dryer face halfway.
With one hand holding the top
of the door and the other hand
holding the bottom, remove the
door from the dryer by lifting it
UP and OUT.
6
7
8
9
Rotate the door 180°. Insert it
on the opposite side of the open-
ing by moving the door IN and
DOWN until the top hinge and
the bottom hinge are resting on
the top screws inserted in step 3.
Remove the remaining screws
from the side of
tie
opening
from which the door was
removed. With these screws
secure each hinge at the bottom.
Tighten the two top screws of
each hinge.
Reinsert the plastic plugs on
the side from which the door
was removed.