Filter
Top Products
Before you call for service…
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Customer ServiceTroubleshooting TipsOperating InstructionsSafety Instructions
17
OPERATION Possible Causes What To Do
Control pads not
Controls accidentally put in • Press
STOP/CANCEL
.
responding
service mode
Dryer doesn’t start
Control panel is “asleep” • This is normal. Press START twice to choose the last cycle
you used and to start the dryer.
Dryer is unplugged • Make sure the dryer plug is pushed completely into
the outlet.
Fuse is blown/circuit breaker is • Check the house fuse/circuit breaker box and
tripped replace fuse or reset breaker.
NOTE:
Most electric
dryers use two fuses/breakers.
Dryer doesn’t heat
Fuse is blown/circuit breaker is • Check the house fuse/circuit breaker box and
tripped, the dryer may tumble replace fuse or reset breaker.
but not heat
Gas service is off • Make sure gas shutoff at dryer and main shutoff are
fully open.
Dryer shakes or makes
Some shaking/noise is normal. • Move dryer to an even floor space, or adjust
noise
Dryer may be sitting unevenly leveling legs as necessary until even.
Inconsistent drying times
Type of heat • Drying time will vary according to the type of heat used.
If you recently changed from an electric to a gas
(natural or LP) dryer, or vice versa, the drying time
could be different.
Type of load and • The load size, types of fabric, wetness of clothes, and the
drying conditions length and condition of the exhaust system will affect
drying times.
No numbers displayed
Dryer is continuously monitoring • This is normal. When the dryer senses a low level of
during cycle, only
the amount of moisture in moisture in the load, the dryer will display the dry
“racetrack” lights
the clothes time remaining.
Est. Time Remaining
The estimated time may change • This is normal.
jumped to a
when a smaller load than usual
lower number
is drying
Clothes are still wet
The door was opened mid-cycle. • A dry cycle must be reselected each time a new load
and dryer shut off after
The load was then removed from is put in.
a short time
the dryer and a new load put in
without selecting a new cycle
Small load • When drying only a few items, choose
SPEED DRY
.
Load was already dry except for • Choose SPEED DRY to dry damp collars and waistbands.
collars and waistbands In the future, when drying a load with collars and
waistbands, choose
MORE DRY
.