Filter
Top Products
Automatic Cycle
Signal
8
Operating Instructions Safety InstructionsCustomer Service Troubleshooting Tips
About your dryer features.
End of Cycle Signal
This signal will sound just before the end
of the cycle to remind you to remove the
clothes. On some models, the signal sound
level can be adjusted.
If you selected the
WRINKLE CARE
option
the signal will sound at the end of the
drying time and will sound several times
during the
WRINKLE CARE
cycle. This will
remind you that it is time to remove the
clothes.
NOTE:
■
Remove garments promptly at the sound
of the signal. Place clothes on hangers
so wrinkles won’t set in.
■
Use the END OF CYCLE SIGNAL especially
when drying fabrics like polyester knits
and permanent press. These fabrics should
be removed so wrinkles won’t set in.
Drum Lamp
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the
circuit breaker. Reach above dryer
opening
from inside the drum. Remove the
bulb and
replace with the same size bulb.
Wrinkle Care
Use this option to minimize the wrinkles
in clothes. It provides approximately 15
minutes of no-heat tumbling after the
clothes are dry.
This option can only be used with the
COTTONS
,
EASY CARE
,
DELICATES
, and
ULTRACARE
cycles. If you are using the
CYCLE
SIGNAL
and you select the
WRINKLE CARE
option, a signal will sound at the end of the
drying time and several times during the
WRINKLE CARE
cycle. This will remind you
that it is time to remove the clothes.
If
WRINKLE CARE
is not
ON,
the dryer will stop
once the timer reaches the
WRINKLE CARE
mark on the cycle dial.
Dryness Sensor Cycle–on some models
This feature is only activated in the
COTTONS
,
EASY CARE
,
DELICATES
, and
ULTRACARE
cycles.
The
Dryness Sensor
provides greater
drying accuracy than standard machines,
resulting in shorter dry times and better
clothes care. As the clothes tumble, they
touch a moisture sensor. The sensor will
stop the heating cycle as soon as the clothes
have reached the selected dryness.
On some models, there is a
Dryness
Sensor Cycle
indicator light. This light is
illuminated during automatic cycles.
When the
Dryness Sensor
feature stops the
heating cycle, the light will go out and the
cool down period will begin.
Note:
The clothes will be hot if they are
removed immediately after the indicator
light goes out.
Dryness
Sensor Cycle
Color Logic
Select the correct
FABRIC CARE
setting. Match
the particular color below the words with the
same color on the Cycle Dial.
Example: Drying a load of clothing labeled
permanent press.
Choose the
FABRIC CARE
setting
-—for this
load it would be the
EASY CARE
MED.
HEAT
(which is a particular color).
Turn the Cycle Dial to the area that has
the same color as the
FABRIC CARE
setting
you have chosen—for this load it would be
the
EASY CARE AUTOMATIC.
2
1
(appearance may vary)
Automatic Cycle Signal–on some models
At the end of each cycle there is
approximately 15 minutes of no-heat
tumbling after the laundry is dry.
A reminder signal will sound periodically
during this time to remind you to remove the
laundry.