Filter
Top Products
$85;)2,9/55:04.$069
#(<,:03,(4+354,?",<0,=:/,*/(8:954:/,-5225=04.6(.,9
58<090:8841)6+-;+75'5;3(?45:4,,+:5*(22-589,8<0*,
-.7:-A7=+)44.7:;-:>1+-C
:7*4-5 7;;1*4-)=;-; %0)<"77
:A-:,7-;6E<;<):< Dryer is unplugged • Make sure the dryer plug is pushed completely into
the outlet.
Fuse is blown/circuit breaker • Check the house fuse/circuit breaker box and replace
is tripped fuse or reset breaker. "Most electric dryers use
two fuses/breakers.
:A-:,7-;6E<0-)< Fuse is blown/circuit breaker is • Check the house fuse/circuit breaker box and replace
tripped; the dryer may tumble both fuses or reset both breakers. Your dryer may tumble
but not heat if only one fuse is blown or one breaker is tripped.
Gas service is off • Make sure gas shutoff at dryer and main shutoff are
fully open.
No heat temperature • Select another heat setting.
selected
:A-:;0)3-;7: Some shaking/noise is normal. • Move dryer to an even floor space, or adjust leveling legs
5)3-;671;- Dryer may be sitting unevenly as necessary until even.
:-);A;87<;76+47<0-; Improper use of fabric softener • Follow directions on fabric softener package.
Drying dirty items • Use your dryer to dry only clean items. Dirty items can
with clean ones stain clean items and the dryer.
Clothes were not • Sometimes stains which cannot be seen when the clothes
completely clean are wet (66,(8after drying. Use proper washing procedures
before drying.
16<76+47<0-; Lint filter is full • Clean lint screen before each load.
Improper sorting • Sort lint producers (like chenille) from lint collectors
(like corduroy).
Static electricity can attract lint • See suggestions in this section under !""
Overloading • Separate large loads into smaller ones.
Paper, tissue, etc., left in pockets • Empty all pockets before laundering clothes.
!<)<1+7++=:; No fabric softener was used • Try a fabric softener.
• Bounce
®
Fabric Conditioner Dryer Sheets have been
approved for use in all GE Dryers when used in accordance
with the manufacturer’s instructions.
Overdrying • Try a fabric softener.
• Adjust setting to !! ' or '.
Synthetics, permanent press • Try a fabric softener.
and blends can cause static
6+76;1;<-6< Type of heat • Automatic drying times will vary according to the type
,:A16/<15-; of heat used (electric, natural or LP gas), size of load,
types of fabrics, wetness of clothes and condition of
exhaust ducts.
12