Filter
Top Products
PROBLEM
WATER WON’T
DRAIN
WATER LEAKS
WASHER IS NOISY
WASHER PAUSES
IN CYCLE
POSSIBLE CAUSE AND REMEDY
c Make sure drain hose is not kinked.
● Top of drain outlet should be less than 8 ft. above floor.
● Make sure hose connections are tight at faucets.
● Make sure end of drain hose is correctly inserted in and secured to drain facility.
● Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Installation Instructions.
● A sharp distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission “locks in? This sound is normal.
● Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases, (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary) the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, open the lid and redistribute the load evenly about the wash basket. Close
the lid and restart.
● Washer normally pauses between washing steps. .
.such as between wash and spin or
between spin and rinse.
If you need more help.. .cail, toll free:
GE Answer Center@
800.6262000
consumer information service
25
..-—. -----