Filter
Top Products
5. Add detergent, bleach and fabric softener to automatic dispenser following these steps:
A. OPENING AND CLOSING THEDISPENSERDRA WER C,
Slowly open the dispenser drawer.
After adding laundry products, slowly close the
dispenser drawer. Closing the
drawer too quickly could result in early
dispensing of bleach or fabric softener.
Note: From time to time you may seewater in the
bleach and fabric softener compartments. This is a
result of the siphoning action and is part of the normal
operation of the washer.
\
\
LIQUID BLEACH
If desired, measure out the recommended amount of
liquid chlorine bleach (not to exceed 1/3 cup (80 mL))
and pour it into the center compartment labeled
"Liquid Bleach" and marked with this symbol_ .
Fillto the mininum fill line (MIN.)for small loads. Fillto
the maximum fill line (MAX.) for large loads. Do not
exceed the maximum fill line. Overfilling can cause
early dispensing of the bleach which could result in
damaged clothes.
Do not pour undiluted liquid chlorine bleach directly
onto the load or into the drum. Fabric damage can
Occur.
• Add powder or liquid color-safe bleach to the
detergent dispenser.
B. DETERGENT
Detergent isflushedfrom thedispenseratthe beginning
of the cycle. Either powdered or liquid detergent can
be used. Note: Liquid detergent will drain into the
washer drum as it isadded.
Add a low-sudsing, high-efficiency
detergent madefor front-loading
washers to the dispenser chamber.
Look for this symbol on the detergent
label. Usethe capor scoop provided bythe detergent
manufacturer to measurethe amount recommended.
Color-safebleach,water conditioner, detergent booster
and enzyme products may be added to the detergent
compartment. Avoid mixing liquids and powders.
Detergent usage may need to be adjusted for water
temperature, water hardness, load sizeand soil level.
Forbest results, avoid oversudsing.
D.
\
FABRIC SOFTENER
If desired, pour the recommended amount of fabric
softener into the compartment labeled "Fabric
Softener" and marked with this symbol_
l
Fillto the mininum fill line (MIN.) for small loads. Fill
to the maximum fill line (MAX.) for large loads. Do not
exceed the maximum fill line. Overfilling can cause
early dispensing of the fabric softener which could
result in stained clothes.
• Do not pour fabric softener directly on the wash
load.
Use of a fabric softener dispensing ball is not
recommended in tumble action washers.