Filter
Top Products
13
Cycle selector is not in correct position.
Motor is overheated.
Lid is not completely closed.
Heavily soiled items.
Washer is overloaded.
Load is out of balance.
Drain hose is kinked.
Lid is not completely closed.
Water supply is not adequate in area.
Water supply faucets are not completely open.
Water is being used elsewhere in the house.
Water inlet hoses are kinked.
Washer is overloaded.
Hot water heater is set too low or is a
distance from laundry center.
Hot water is being used elsewhere in
the house.
To conserve energy, the temperature of
the hot wash is regulated.
Drain hose is kinked or clogged.
Loose fill hose connection at faucet or
washer.
House drain pipes are clogged.
Oversudsing.
Hot and cold water hoses are connected
to wrong supply faucets.
Drain hose standpipe is incorrect height.
Move indicator clockwise slightly. Pull out knob.
Washer motor will stop if it becomes overheated. It will
automatically restart after a cool down period of up to 30
minutes (if washer has not been manually turned off).
Close lid completely. Safety lid lock must not be broken.
Wipe tub with a nonabrasive household cleanser, then
rinse. Shake or brush excess dirt and sand from items
before washing.
Do not overload washer. See Washing Procedures.
Rearrange load to allow proper spinning.
Straighten drain hose.
Close lid completely. Washer will not fill with water when
the lid is open.
Check another faucet in the house. Wait until water
supply and pressure increase.
Fully open hot and cold faucets.
Water pressure must be at least 30 psi (260 kPa). Avoid
running water elsewhere while washer is filling.
Straighten hoses.
Do not overload washer. When control is set at highest
fill level, dry load level should not be higher than top row
of circular holes in wash tub.
Measure hot water temperature at nearby faucet with
candy or meat thermometer. Water temperature should
be at least 120°F (49°C). Adjust water heater as necessary.
Avoid using hot water elsewhere before or during washer
use. There may not be enough hot water available for
proper cleaning. If problem persists, your hot water
system may be unable to support more than 1 use at a
time.
See Operating Instructions for your washer
Clean and straighten the drain hose.
Check and tighten hose connections. Install rubber sealing
washers provided.
Unclog drain pipes. Contact plumber if necessary.
Use less detergent.
Connect hot water hose to hot water faucet and cold
water hose to cold water faucet.
Standpipe must be a minimum of 33" (83.82 cm) high to
prevent siphoning. See INSTALLATION INSTRUCTIONS.
Washer does not start
(continued).
Washer won't spin.
Residue left in tub.
Wash load too wet after
spin.
Water does not enter
washer or it enters slowly.
Water level does not cover
load.
Warm or hot water is not
hot enough.
Water in washer does not
drain or drains slowly.
Water leaks.
Incorrect wash and rinse
temperatures.
Water is entering washer
but tub does not fill.
OCCURRENCE POSSIBLE CAUSE
SOLUTION
WASHER - WATER
WASHER - OPERATING (continued)