Filter
Top Products
13
OPERATING INSTRUCTIONS
Cycle Settings, continued
This manual covers many models and not all cycles, options, or features listed are available
on every model. Console shown above for reference only. Your model may differ.
To select or delete the Energy Saver (if equipped), Extra
Rinse, Stain Clean, Extended Spin (if equipped) or Signal
Volume, press Options until the blinking light indicates
the desired option. Then, while it is blinking, press
Select. The indicator will light when the option has been
selected. It will no longer be lighted when the option has
been removed.
Not all options are available on every model or are
compatible with every cycle. The indicator will not light if
the option is not available with that cycle.
The options selected for the cycle will be remembered and
recalled each time that cycle is selected in the future. To
return to factory settings, press the Start/Pause and Select
buttons at the same time and hold until the signal sounds.
Energy Saver (on select models)
The Energy Saver option reduces the warm water
temperature a few degrees to save energy and also
extracts more water to reduce drying time.
Extra Rinse
Use this option when additional rinsing is desired to
remove excess dirt and detergent. It is recommended
for heavily soiled loads or if household members have
sensitive skin. Extra Rinse occurs before the final rinse
when the liquid fabric softener is dispensed.
SOIL LEVEL
Adjust the wash time in 3-minute increments based on
the soil level of each load. Heavy, Normal, and Light Soil
Levels are available.
Cycle Options
Other Features
NOTE
To change the options once the cycle has begun, press
the pause button, make the new selection and press
start again.
Stain Clean
Use the Stain Clean option to add a 5-minute soak in
the middle of the wash portion of any cycle except
Quick and Hand Wash.
Extended Spin (on select models)
Use this option to add several additional minutes to the
final spin at the selected speed. This will improve water
extraction and decrease drying time.
Signal Volume
A signal will sound at the end of the cycle if this option
is selected. The signal has an adjustable volume level
or can be turned off.
Delay Start
Press Delay Start to select a wash time convenient to
your schedule or during off peak energy hours. The start
of the cycle can be delayed for up to 14 hours. The delay
time selected will be displayed as 30, 60 or 90 minutes or
2 through 14 hrs.
Control Lock
To avoid having someone accidentally start or stop the
washer, press Options and Select at the same time and
hold for 10 seconds until “
LOC
” is displayed alternately
with the estimated cycle time. To unlock the controls,
press Options and Select at the same time and hold 10
seconds until “
LOC
” is no longer displayed.
Status Display/Status Lights
The estimated total cycle time will be displayed when
the cycle is selected. The time may increase if water
pressure is low, oversudsing occurs or the load becomes
unbalanced. The estimated remaining cycle time is
displayed during the cycle. The following indicators may
be lighted during the cycle:
Door Lock•
Rinse•
Final spin•
Touch Pause to Add a Garment•
Drum Light (on select models)
The drum light will turn on when the washer door is opened
and remain lighted for 3 minutes or until the door is closed.