The AquaSmart™ washer has two modes of washing, High Efficiency and Conventional.
Both modes start the same way, with a Detergent Activating wash.
Detergent Activating wash
AquaSmart™ fills the bowl at the selected water temperature,
with just enough water so the clothes are saturated. This small
amount of sudsy water flows through the clothes, up a specially
designed portal and back onto the clothes in a waterfall effect. This
thoroughly dissolves and activates the detergent.
High Efficiency mode
In the High Efficiency mode the AquaSmart™ then fills with just
enough cool water to lift the clothes off the low profile agitator so
when it rotates, the clothes gently roll over each other. This wash
uses similar quantities of water to most Front Loaders. Not only
do you get the benefits of water savings but the higher detergent
concentrations give you optimum soil removal.
Conventional mode
The Conventional mode is the immersion wash all Top Loader users
are familiar with. After the Detergent Activating wash the AquaSmart™
fills with cold water until the clothes are submerged, and gently turns
the clothes over. We recommend this mode when the dilution effect
of water can solve or prevent common wash problems. For example,
when dye or colour run can be a problem, or when washing sandy
towels. The SHEETS cycle uses the Conventional mode.
Some cycles can be used in both modes, whilst others work in only one.
High Efficiency Conventional
Regular
Heavy
Delicate
Sheets –
Colours –
Bulky –
Easy Iron –
These two wash modes mean that your AquaSmart™ washer gives you the best of both worlds,
to suit any laundry situation.
Fig.7 Detergent Activating wash
Fig.8 High Efficiency wash
Fig.9 Conventional wash
The unique AquaSmart™ wash
8