Filter
Top Products
32
Saving Water
Manual Suds Save With Syphon Back
If you have a large tub near your washing machine and a separate drain outlet you can set up
another method of reusing the water.
(The tub should hold a minimum of 100 litres or have an overflow).
1
Select SOAK on the first wash cycle.
2
At the end of the wash phase place the drain hose in the tub.
3
Cancel SOAK (press ADVANCE button). The suds water
will be pumped into the tub. Do not leave your machine
until pump out is completed.
4
Once your tub is filled return the drain hose to the
drain. This must be done before the machine starts
spinning.
5
Allow the machine to complete the rest of the cycle.
Remove the first wash load and place the second load in
the machine.
6
To syphon back the suds place the end of the drain hose
in the tub, ensure that the end is near the bottom of the
tub.
7
Advance to SPIN and allow the machine to pump for a
few seconds to clear air from the drain hose, then press
POWER to turn the machine off.
8
The suds water will syphon back into the machine. It will
take several minutes to syphon back the water.
9
RETURN HOSE TO DRAIN.
10
Select second wash cycle.
The above method can also be used to recycle the water from a deep rinse. Select SPIN HOLD
in place of SOAK.
Note:
For any of the above methods, manually select the water level for the second wash load. Auto
Water Level may fill to a level too high for the clothes load if there is already water in the wash
bowl.
Note: You will only be able to syphon
back into the machine until the water
level is equal to that in the tub.